Note: The Hemiboots are not compatible with ANY reinforced drive cups.
These are the first NON rotating axle boots to hit the Baja market. They replace the stock axle boots, and provide all the protection you ever wanted for your drive train set up. Since they do not rotate, they will not be dealing with the same wear as the standard boots. Drive cups, driveshaft and differential bearings are all very well protected and therefore have a much longer lifespan. The HemiBoots are tough enough to handle any type of surface you run them on.
Installation is simple and done in a matter of minutes. Clear installation instructions are provided on the back of the package. HemiBoots consist of three parts on each side of the transmission box. A hard plastic connector, which clicks on the side of the transmission, a hard plastic ring that is to be glued in the hub carrier, and a boot made from a heavy duty rubber component, that seals around both ends, making sure no unwanted stuff will get in your drive cups ever again.
Running Hemiboots combined with the HPI 5T, SS or RTR V2 arms causes clearance issues due to the shock touching the rubber. Using HemiRisers takes care of this matter and will allow for compatibility.
COST: $85.00
e43b2e6e-c134-421c-8886-4902ba491e47|1|5.0